The drivers and pillion rider's seat are equipped with a fluting in order to release the tail bone. The seats were also broadened for about 15mm.
The padding consists of two layers, the upper one comfortably soft and the lower one avoids denting. We especially took care of the pilion rider's comfort:
Here, the seat is increased in the middle front part to inhibit a cramped position.
These alterations care for a tangible comfortable riding - free from pain. Also the vexatious sliding when the driver brakes has an end now.
The seats are slippage related material.
Available in three heights:
1: like the original one
2: lower (- ca. 25mm)
3: higher (+ ca. 25mm)
It s possible to change the seat with heater.
Your seat gets altered - you have to send it in!
The change takes about 2 weeks.
Your spec sheet: Fill out the form and send it with your seat!
Every picture of the service "seat alteration" can of course only be an example! Seams are for example not possible when you want the seat to be very soft!
IMPORTANT INFORMATION: The higher a seat should be, the harder it must be to avoid wrinkles. If a seat should be higher and soft, wrinkles are inevitable in leather with time!