In the section Carbon fibre ✅,GRP you will find very beautiful accessories to further customize your BMW S1000R. Just like your S1000R Carbon or glass fibre reinforced plastic (GRP) stand for high quality and uniqueness. Especially the tank area of your BMW should be protected from zippers and buttons. Therefore, we offer paint protection pads made of 3M Carbon foil. However, if you only want protection for your petrol cap, our petrol pad would be a solution which consists of 3 parts. Our rear hugger and front fender put your bike into an entirely new, different light. So you bring out the main points and make your S1000R unique. Also the number plate holder impresses on your BMW . Like any other carbon parts from our shop it is made of high quality carbon fibre and covered with UV resistant clear lacquer. You will also find an alternator cover in this category. Although our clutch cover is small, it achieves a big effect. The swingarm cover left and right is simply glued on with silicone glue and is absolutely secure. Especially on the race track our ignition rotor cover is essential. Our upper tankcover optically enhances your S1000R again and blends perfectly with the overall image. This rear light cover is made of high quality carbon fibre and replaces the original unpainted plastic part perfectly. There is a front fairing in our range of products, specifically for your BMW S1000R, too.
Our frame protectors, made of high quality carbon fibre, are attached to the frame by using the adhesive strips inside the carbon parts. A further step in the direction of individualisation you make with our Carbon front sprocket cover. This GRP (glass fibre reinforced plastic) front mudguard will be shipped with a German "Materialgutachten" (material homologation). Please mount the fairings before you paint it in order to see if everything fits perfect. The wind protector next to the instruments made of Carbon fibre is a direct replacement for the original component. Our Bellypan is made of high quality Carbon fibre. The whole product is made of one piece and specially designed for the street. It has ABE/street homologation and you can use it with the original BMW pre-muffler and you can use it with the original sidestand. Our side panels, made of high quality Carbon fibre, provide not only a motorsport look but also an advantage in weight!
The Carbon fibre water cooler cover also replaces the original plastic part and uses the original mounting points. The tank side panels blend harmoniously into the overall appearance of your S1000R. Our Carbon tail fairing kit consists of two parts which get fixed on the left and right side of the bike.
